Toyota Avalon (XX50): Front seats

Toyota Avalon (XX50) 2019-2022 Owners Manual / Operation of each component / Adjusting the seats / Front seats

Adjustment procedure

Seat position adjustment switch
Seatback angle adjustment switch
Seat cushion (front) angle adjustment switch
Vertical height adjustment switch
Lumbar support firmness adjustment switch (if equipped)
Lumbar support height adjustment switch (if equipped)

Adjusting the seats

■Power easy access system (vehicles with driving position memory) The driver's seat and steering wheel move in accordance with engine switch mode and the driver's seat belt condition.

WARNING

■When adjusting the seat position

Take care when adjusting the seat position to ensure that other passengers are not injured by the moving seat.
Do not put your hands under the seat or near the moving parts to avoid injury.

Fingers or hands may become jammed in the seat mechanism.
Make sure to leave enough space around the feet so they do not get stuck.

■Seat adjustment

Be careful that the seat does not hit passengers or luggage.
To reduce the risk of sliding under the lap belt during a collision, do not recline the seat more than necessary.

If the seat is too reclined, the lap belt may slide past the hips and apply restraint forces directly to the abdomen, or your neck may contact the shoulder belt, increasing the risk of death or serious injury in the event of an accident.

Adjustments should not be made while driving as the seat may unexpectedly move and cause the driver to lose control of the vehicle.

NOTICE

■When adjusting a front seat When adjusting a front seat, make sure that the head restraint does not contact the headliner. Otherwise, the head restraint and headliner may be damaged.

Adjusting the seats

Rear seats

See More:

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Cold Start Idle Control System Performance (P050A00)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the eng ...